Hair Routine for High-Porosity, Medium-Volume, Fine-Textured 4A-4C Coils (HQR53-56)

take an extra 15% off 3 or more of your product recs: Use code : 3plus  Shop Now

And, here's your customized hair routine for treating, cleansing, conditioning, and styling your high porosity, medium volume, fine-textured, Type 4 coily strands:

TWA requires very little to no maintenance. Just make sure that you keep your hair hydrated with COILBAR Light-weight Hydrating Leave-In Liquid Conditioner or COILBAR Curl Revitalizing Spray or COILBAR Light-weight Moisturizing Curl Refresher.


SHORT half-inch to 2-inch ‘do can easily be detangled with your fingers. If hair is very short, use palm of your hand to rub in circles to create texture. For slightly longer hair, twist around finger to create curls and coils.


With a MEDIUM 2-inch to 10-inch 'do you can detangle your hair with fingers and follow with a wide tooth comb. You should separate your hair into sections when washing and styling, and only need to use a quarter-sized amount of styling product per section.


A LONG, 10-inch plus, armpit to waist-length locks should be detangled in sections, first with your fingers followed by a wide-tooth comb. At the minimum you'll need to use two quarter-sized dollops of styling product per section. To preserve your 'do overnight you can use a scrunchie to pineapple hair.


STEP 1: PRE-POO TREATING & DETANGLING

pro styling tip — pre-poo fine hair before shampooing and conditioning.

— strengthening (protein) treatment: Once or twice a month apply COILBAR Dead Sea Mud Deep Conditioning Hair Mask Treatment or COILBAR Deep Conditioning Protein Hair Mask.

— Pre-poo detangling: Apply COILBAR Intense Hydrating Conditioner or a small amount of COILBAR Hair Growth Oil or COILBAR Daily Growth Oil or saturate your hair with water and then apply COILBAR Volumizing Conditioner. Detangle slowly and carefully, section by section, with your fingers or a wide-toothed comb. Loosely twist or clip each section with a duckbill clip as you complete it.

— Pre-poo oil treatments:

Overnight oil treatment: Apply 2 tablespoons of COILBAR Hair Oil Treatment. Rub it onto your strands from tip to root. If saturating strands, follow with COILBAR (Low Poo) Oil-Infused Clarifying Shampoo. Don a plastic cap and cover with your satin cap.

Hot oil treatment: Heat 2 tablespoons of COILBAR Hair Oil Treatment. Apply sparingly to the length of your hair and focus on the ends, which are the most delicate. Massage gently into your scalp for several minutes. Allow to sit for 15 minutes. Proceed to shampoo with COILBAR (Low Poo) Oil-Infused Clarifying Shampoo.

STEP 2: CLEANSING

— co-washing & clarifying: Co-wash regularly with COILBAR Silkening Co-Wash alternating with COILBAR (Low Poo) Oil-Infused Clarifying Shampoo

— Deep cleansing: To remove sebum and scalp oils occasionally shampoo with COILBAR Deep Cleansing Hair & Scalp Shampoo thoroughly twice. Completely rinse off the shampoo until it squeaks. If it does not squeak you are using the wrong shampoo for your fine hair.

STEP 3: CONDITIONING

— deep conditioning: Deep condition regularly with COILBAR Intense Hydrating Conditioner. Rub the deep conditioner between your hands to ensure evenness. Then apply the deep conditioner three to four inches away from the root and to the ends.

— Regular conditioning: Apply COILBAR Volumizing Conditioner to the ends. Rub the rinse out conditioner between your hands to ensure evenness. Then apply the rinse out conditioner three to four inches away from the root and to the ends. Begin detangling with your fingers or a pick. After the ends are detangled, rinse lightly and then apply more COILBAR Volumizing Conditioner to the scalp. Rinse hair in one direction thoroughly from the scalp down to minimize possible tangles. Do this under the shower where you wash away the conditioner while untangling your curly hair. Using our COILBAR T-Shirt Towel to squeeze out excess water from the hair. Do not rub hair. Continue detangling hair using your fingers, a hair pick or a wide-toot comb starting at the nape of the neck.

— Conditioning treatments:

For lowering hair porosity: Use COILBAR Intensive Scalp Detox Treatment Masque followed by COILBAR Volumizing Conditioner to smooth and coat the hair shaft and temporarily lower porosity. Do a final rinse with cool water to seal the cuticle. Leave conditioner in; you can even add more after rinsing.

for dry and dull ends: On an as-needed basis use COILBAR Light-Weight Deep Moisturizing Conditioner or COILBAR Detoxifying Deep Conditioning Hair Mask when hair ends look dry and dull.

STEP 4: PRODUCT COCKTAILING & STYLING for volume, definition, and hold

layer styling products without being heavy-handed to avoid product overload, to add volume, to define curls, and to extend the number of days without having to re-moisturize your curls. section hair into three or four parts to provide good product distribution and to ensure that no one area gets too much product.


step 4a: Add moisture to curls:

Divide hair into sections. Apply COILBAR Light-weight Moisturizing Detangler onto soaking wet hair (for low to medium porosity hair) or damp hair (for medium to high porosity hair) that is freshly cleansed, conditioned, and detangled to provide hair with moisture.

Place a plastic cap over hair until you are ready to complete styling with step 4b. Doing so will keep hair warm and well-saturated.

Step 4b: Seal moisture into curls:

Use three to four drops of COILBAR Growth Oil. Rub it in your palms to heat it up. Dab it sparingly along the length of your hair. Remember to apply your sealant sparingly and do not slather oils onto your scalp to prevent weighing down hair.

Step 4c: Define curls:

Apply COILBAR Volumizing Medium to Firm-Hold Curl Defining Mousse, work it in, and then use the COILBAR Detangling Brush to help form curl clumps.

Step 4d: Add more definition, volume and hold to curls:

For wash and gos emulsify 2-3 pumps of COILBAR Medium-Hold Moisturizing Argan Oil Styling Gel or COILBAR Light-Weight Medium-Firm Hold Curl Gel with 6-8 sprays of COILBAR Firm-Hold Volumizing Shine Spray between your palms. Scrunch this mixture into your hair from the mid-shafts to the roots, scrunching upwards. Scrunch your roots with a COILBAR T-shirt towel to remove excess water, wait five minutes, and scrunch your roots again with your hands. This will prevent your roots from drying flat.

— SPOT VOLUME: If you have a small area of hair that always seems to fall flat no matter what you do, thoroughly saturate the section, apply COILBAR Light-weight Moisturizing Detangler and COILBAR Volumizing Medium to Firm-Hold Curl Defining Mousse. Using a duckbill clip, root clip the section on a diagonal, lifting it slightly at the base. Spritz the roots with COILBAR Firm-Hold Volumizing Shine Spray, and then allow them to dry.

PRO STYLING TIP — amp up the staying power of volumizing spray by applying COILBAR Firm-Hold Volumizing Shine Spray on hair that is slightly damp. When spraying, focus on the roots of your hair to the mid-shafts, and then scrunch upwards. Start with a couple of spritzes and gradually add more as needed.

For medium to high-manipulation styles such as twists, bantu knots, braids, etc., use COILBAR Light-Hold Twisting Hair Butter or COILBAR Flax Seed Gel-Cream Curl Definer or COILBAR Medium-Weight Medium-Hold Curl Defining Cream.

PRO STYLING TIP — use heavy butters in the winter months in cold-weather locales and use light butters or lighter natural oils in warm weather and warm-weather locales.

Step 4e: Dry and set curls with volume:

Overnight drying: Pull your hair up into a loose pineapple when your hair is 90% dry to lift roots.

Air drying: Position your hair in the style you desire. Part the hair where you want the demarcation to be and reach up and under with your fingertips lifting the hair while it dries and pull it up to give it more fullness.

Diffusing: Use a dryer with a diffuser on the scalp only to set the base of the hair up. Squeeze hair ends. Scrunch and wad the hair up towards your roots, and lift the base of your hair with your fingers.

Step 4f: Style curls only after hair is COMPLETELY dry:

— For a wash and go: Apply a small amount of COILBAR Hair Growth Oil to hands. Next, gently scrunch out the crunch or flip your head over and lightly pick out your roots after your hair is completely dry. Don’t touch your curls. 


— For medium to high-manipulation styles such as twist-outs, bantu knots, braid-outs, etc.: Apply a small amount of COILBAR Hair Growth Oil to your hands, then gently un-twist or un-braid your hair. Next, lightly pick and/or fluff out your roots.

PRO STYLING TIP — Play with hair throughout the day to expand and puff hair.

STEP 5: MAINTAINING YOUR STYLE

Refreshing and moisturizing tired curls, late-day, second-day wash and gos, or slept-in styles: Spray into hair COILBAR Light-weight Hydrating Leave-In Liquid Conditioner or COILBAR Curl Revitalizing Spray or COILBAR Light-weight Moisturizing Curl Refresher to refresh second-day hair or frizzy curls, to keep hair feeling soft, and to perk up listless curls.


Spot treating: Spritz dry areas of hair with COILBAR Curl Revitalizing Spray. If your hair requires more moisture, apply a small amount of COILBAR Light-weight Hydrating Leave-In Liquid Conditioner. Gently massage the moisturizer into the dry sections of your hair. Then, scrunch or twist areas that have lost definition.



take an extra 15% off 3 or more of your product recs: Use code : 3plus  Shop Now
×